Roland VP-770 - Manual (Page 84)

84
REGIST PEDAL
Parameter Value Description
Hold Part Specifi es the part(s) that will be controlled by the hold pedal.
VOC/ENS Vocal Designer part and Ensemble part.
VOC Vocal Designer part only.
ENS Ensemble part only.
P1 Asgn
P2 Asgn Specifi es the function that will be controlled by the control pedal.
OFF Off
MOD Applies modulation.
DYN1 Changes the volume. Transmits MIDI message CC#2 (breath control) to the
sound generator section. This is the same operation as Voice Expression
(p. 66), and will operate only in the positive (+) direction to increase the
volume.
DYN2 Changes the volume. Transmits MIDI message CC#4 (foot control) to the
sound generator section. For STRINGS and BRASS sounds, this allows the
volume to be controlled in the ± directions (it will not go to zero). For other
sounds, the volume can be controlled only in the “+” direction.
EXP Changes the volume. Transmits MIDI message CC#11 (expression) to the
sound generator section. The volume is controlled in a range of 0–127.
FILTER Changes the tone.
WAH Applies a wah pedal eff ect to sounds that support Wah.
PIZZ/STAC Plays the pizzicato or staccato sound (only for supported tones).
FALL/TREM Plays the fall or tremolo sound (only for supported tones).
UNI/STK Switches between unison mode and stack mode (only for supported tones).
DOIT Applies a doit eff ect (only for supported tones).
PORT Applies a portamento eff ect.
AMB Controls the depth of ambience.
DIR-MIC Controls the direct microphone volume.
PANEL-SW Performs the operation specifi ed for P1 Sw Asgn/P2 Sw Asgn.
P1 Sw Asgn
P2 Sw Asgn If P1 Asgn/P2 Asgn is set to “PANEL-SW,” this specifi es the operation that
occurs when the control pedal turns on.
REC/PLAY Same operation as Sound Looper [REC/PLAY] button.
Rapidly pressing the pedal twice performs the same operation as the [STOP] button. *
STOP Perform the same operation as Sound Looper [STOP] button.
P1 Part
P2 Part Specifi es the part(s) that will be controlled by the control 1/2 pedals.
VOC/ENS Vocal Designer part and Ensemble part.
VOC Vocal Designer part only.
ENS Ensemble part only.
REGIST S1/S2
Parameter Value Description
Sw1 Assign
Sw2 Assign Specify the functions that will be controlled by the [S1]/[S2] buttons.
OFF Off
PIZZ/STAC The pizzicato or staccato sound will be heard (only for supported tones).
FALL/TREM The fall or tremolo sound will be heard (only for supported tones).
UNI/STK Switches between unison mode and stack mode (only for supported tones).
DOIT Applies the doit eff ect (only for supported tones).
PORT-ENS Applies the portamento eff ect to the Ensemble.
PORT-VOC Applies the portamento eff ect to the Vocal Designer.
AMB-OFF Switches the ambience when you press the button.
DIR-MIC-OFF Switches the direct microphone when you press the button.
Sw1 Mode
Sw2 Mode Turns the [S1]/[S2] buttons function LATCH/MOMENTARY.
LATCH The on/off status will alternate each time you press [S1]/[S2] button.
MOMENTARY The status will be on only while you hold down [S1]/[S2] button.