Ryobi P541 - Manual (Page 9)

3 - English
GENERAL SAFETY RULES
READ ALL INSTRUcTIONS
BASIc SAFETY PREcAUTIONS
 Do not operate a chain saw with one hand! Use
a firm grip with thumbs and fingers encircling the
chain saw handles. Serious injury to the operator,
helpers, bystanders, or any combination of these
persons may result from one-handed operation.
A chain saw is intended for two-handed use.
 Always be aware of what you are doing when
using the chain saw. Use common sense. Do
not operate the chain saw when you are tired,
ill, or under the influence of alcohol, drugs, or
medication.
 Stay alert and pay attention to what you are
doing. Use common sense when using this
unit.
 Keep all parts of your body away from the saw
chain when the unit is running.
 Always carry the chain saw by the front handle
with the unit stopped and the guide bar and saw
chain positioned to the rear. When transporting
your chain saw, use the appropriate guide bar
scabbard.
 Never let anyone use your chain saw who has
not received adequate instructions in its proper
use. This applies to rentals as well as privately
owned saws.
 Before you start the unit, make sure the saw
chain is not contacting any object.
 Stop the chain saw before setting it down. Do
not leave the unit running unattended.
 To avoid accidental starting, never carry the unit
with your finger on the trigger.
 Maintain the unit with care. Keep the cutting
edge sharp and clean for best performance
and to reduce the risk of injury. Follow instruc-
tions for lubricating and changing accessories.
WARNING:
Do not attempt to operate this unit until you
have read thoroughly and understand com-
pletely all instructions, safety information, etc.
contained in this manual. Failure to comply can
result in accidents involving fire, electric shock,
or serious personal injury.
Inspect the battery charger cord periodically,
and if damaged, have it replaced or repaired by
an authorized service dealer.
 Keep handles dry, clean, and free of oil and
grease.
 Do not operate a chain saw that is damaged,
improperly adjusted, or not completely and
securely assembled. Chain should stop turning
when the trigger is released. If the chain turns
after the trigger has been released, have the unit
serviced by your nearest Ryobi service dealer.
 Check for damaged parts. Any part or guard that
has been damaged should be carefully checked
to determine that it will operate properly and
perform its intended function. Check for align-
ment of moving parts, binding of moving parts,
breakage of parts, mounting, and any other
conditions that may affect its operation. A guard
or other part that is damaged should be properly
repaired or replaced by an authorized service
dealer unless otherwise indicated elsewhere in
this manual.
 All chain saw service, other than the items listed
in the operation and maintenance sections,
should be performed by your nearest Ryobi
service dealer.
 Do not use in the rain, snow or wet condi-
tions.
 Always maintain a proper stance. Do not over-
reach.
 Do not adapt your powerhead to a bow guide
or use it to power any attachments or devices
not listed for the saw.
 Do not cut vines and/or small underbrush.
SAFETY APPAREL
 Wear snug fitting clothing. Always wear heavy,
long pants, long sleeves, overalls, jeans or
chaps made of cut resistant material or ones
that contain cut resistant inserts. Wear non-
slip safety footwear. Wear non-slip heavy duty
gloves to improve your grip and to protect your
hands. Do not wear jewelry, short pants, san-
dals, or go barefoot. Do not wear loose fitting
clothing, which could be drawn into the motor
or catch the chain or underbrush. Secure hair
so it is above shoulder level.