Roland CD-2e - Manual (Page 110)

110
Troubleshooting
If you suspect a malfunction, please check the following points. If this does not resolve the problem,
contact a nearby Roland Service Center.
Power Supply
Problem Cause and Action
See
Page
The power does not turn
on when you move the
[POWER] switch to the
“ON” position. ● Could you be using an AC adaptor other than the included one?
➔ Use included dedicated AC adaptor. 21
●
Could the AC adaptor plug have been disconnected from the CD-2e’s
AC adaptor jack? Could the power cord have been disconnected from
the AC outlet or the dedicated AC adaptor’s connector?
➔ Firmly reconnect the dedicated AC adaptor and power cord. 21
● Could the remaining battery power be insufficient?
➔ Once the battery runs low, the power may not turn on. Install fresh
batteries. 23
● Are the batteries installed in the correct orientation?
➔ Check the “ ” and “ ” orientation of the batteries, and install them
correctly.
22
Screen
Problem Cause and Action
See
Page
The screen is difficult to
read ● Depending on the location or environment in which the CD-2e is
placed, the screen may be difficult to read.
➔
Readjust the display contrast. 95
The screen goes dark ● If you’re using batteries, the Backlight Timer setting will dim the
screen when you haven’t operated the CD-2e for a specified length of
time.
➔ Turn the Backlight Timer “Off.” 96
Unreadable characters
appear on the screen ● Could you have specified the wrong screen display language?
➔ Select the appropriate screen display language. 97
CD-2e_e.book 110 ページ ２００７年１０月２４日 水曜日 午前１１時１６分