Radio Shack 14-518 - Manual (Page 6)

6 CD Player Operation
5. Slide TONE to HIGH to emphasize the
treble sounds or to LOW to emphasize
the bass sounds.
6. To turn off the radio, set FUNCTION to
STD BY.TAPE .
ˆ
CD Player Operation
LOADING AND PLAYING A
CD
1. Set FUNCTION to CD . -- flashes on the
display, then 00 appears.
2. Open the CD door by lifting the tab on
the left of the door. Place a CD in the
center with label facing up, press it down
over the hub to secure it, and then close
the door.
-- flashes for a couple of sec-
onds, then the total number of tracks
appears on the display.
3. Press . to play all the tracks in order,
starting with Track 1. The current track
number appears on the display and the
play/pause indicator (the dot to the right
of the track number) lights.
4. To temporarily pause the CD, press
and the play/pause indicator flashes. To
resume play, press
. again.
5. Adjust VOLUME to a comfortable level.
Adjust TONE to HIGH to emphasize tre-
ble sounds or to LOW to emphasize
bass sounds.
6. The CD stops after playing the last
track. To stop play sooner, press . Wait
a few seconds for the CD to stop turn-
ing, then open the CD door and remove
the CD.
USING AUTOMATIC
SEARCH MUSIC SYSTEM
The automatic search music system lets you
quickly locate the beginning of any track on
the CD, including the current track.
If the CD is playing:
• Press . once to return the beginning
of the current track
• Press . twice to return the beginning
of the previous track
• Press . to skip to the beginning of
the next track
If the CD is stopped, repeatedly press or hold
down
or until the display shows the
desired track number, then press . The
CD player starts playing the selected track.
To search backward or forward within a track
while the CD is playing, hold down either
or . You hear the track play rapidly
and at a lower volume. Release the button to
resume normal play.
PROGRAM
REPEAT
(STOP)
(PLAY/
PAUSE)
SKIP
SKIP
FM ST./
PROG
Indicator
14-518.fm Page 6 Tuesday, October 10, 2000 11:31 AM