Radio Shack 14-518 - Manual (Page 7)

7 CD Player Operation
USING REPEAT PLAY
The system lets you continuously repeat a
single track, all tracks on a CD, or an entire
programmed sequence of tracks.
To continuously repeat a single track, press
REPEAT once so the repeat indicator in front
of the right digit of the track number flashes.
To continuously repeat all tracks on the CD,
press
REPEAT twice so the repeat indicator in
front of the track number lights.
To continuously repeat an entire pro-
grammed sequence, first program the tracks
you want to play (see “Programming
Tracks”), press
then REPEAT twice, so
the repeat indicator lights.
To cancel repeat play during play, repeatedly
press
REPEAT until the indicator turns off.
The CD player resumes normal play.
The repeat indicator remains lit after is
pressed. To cancel repeat play when the CD
is stopped, press
. again or REPEAT once.
PROGRAMMING TRACKS
You can program the system to play up to 16
tracks in any order you choose, and you can
program the same track to play more than
once.
Storing/Playing a Programmed
Sequence
1. With a CD loaded but not playing, press
PROGRAM . Pr flashes on the display
and the FM ST./PROG indicator flashes.
2. Repeatedly press SKIP . or SKIP
until the desired track number
appears.
3. To store the selected track, press PRO-
GRAM . Pr flashes on the display and
the FM ST./PROG indicator flashes.
4. Repeat Steps 2–3 to store up to 16
tracks.
Note: If you try to store more than 16
tracks, the 17th track is not stored and
Pr flashes on the display.
5. Press . to play the programmed
tracks. The first programmed track num-
ber appears and the play/pause indica-
tor and the FM ST./PROG indicator
lights. The CD begins to play starting
with the first programmed track.
Reviewing a Programmed
Sequence
To review a programmed sequence, with
play stopped, press
PROGRAM once (if you
have stored all the tracks in the sequence).
Otherwise, press
PROGRAM twice. The FM
ST./PROG indicator flashes and the track
number of each stored track appears.
Erasing a Programmed Sequence
You can do any of the following to erase a
programmed sequence:
• Set FUNCTION to STD BY.TAPE or
RADIO .
• Open the CD door with play stopped.
• Press with play stopped.
CD AND CD PLAYER TIPS
Even though a compact disc is durable, treat
the CD surface with care.
• Do not write on either side of the CD,
particularly the non-label side. Signals
are read from the non-label side.
• Do not store CDs in high temperature,
high-humidity locations. They might
warp.
• Keep CDs dry. A water drop can act as a
lens and affect the laser beam’s focus.
14-518.fm Page 7 Tuesday, October 10, 2000 11:31 AM