Oregon Scientific JMR868A - Manual (Page 5)

EN
5
Clock:
NOTE The nightlight has a Power ON / OFF switch to
help conserve power. Use the AC adaptor when using
the nightlight for long periods of time. The batteries
are a good power source for back-up usage.
ABOUT ATOMIC CLOCK RECEPTION
This clock can automatically synchronize the date and
time with
an official time-keeping organization in
Boulder, Colorado. The unit can pick up an atomic clock
signal when it is within 932 miles (1500 km) of Boulder.
NOTE For best results, place the unit away from metal
or electrical objects, and near a window with a clear
view to the sky.
TURNING THE ATOMIC CLOCK RECEPTION ON / OFF
To turn the atomic clock reception on:
Press and hold the clock button for 2 seconds.
The atomic clock reception icon will appear and
flash on the display to indicate it is searching for
the atomic clock signal.
Once batteries have been installed in the clock, the
reception icon will flash to indicate it is searching for a
signal.
When the reception signal has been received the
reception icon will show the signal strength by
displaying between 0 and 3 waves:
To turn the atomic clock reception off:
Press and hold the button for 2 seconds.
The atomic clock reception icon will disappear from
the display.
Nightlight:
NOTE Replace the batteries whenever the low battery
icon is displayed. Change all the batteries at the
same time - it is dangerous to mix old and new
batteries. Protect your environment by taking
exhausted batteries to authorized disposal stations.
shows on the clock display when the batteries
are low.
The LED indicator on the motion sensor will flash in
red when the batteries are low.
AC ADAPTOR
The 4.5V AC adaptor connects to the nightlight as
shown below.
STRONG
SIGNAL
WEAK SIGNAL NO SIGNAL
JMR868A_EN_R6 09/21/2004, 11:08 5