Oregon Scientific 3.0 MEGA-PIXEL DIGITAL CAMERA WITH JUMBO DISPLAY PV 100 - Manual (Page 29)

EN
NOTE: You can only specify the DPOF of the internal memory by
transferring the images to a blank SD card via an SD card reader
(sold separately). While you can take your SD card to a specialist for
printing images, you must take the camera to a specialist to print any
images stored in internal memory.
SPECIFYING DPOF OF SELECTED IMAGES
1. When "Select Images" is selected, the OSD displays up to nine
thumbnail images similar to the Multi-Frame Review setting.
Use
to navigate.
2. Highlight an image, then press DISP / OK to confirm your
selection.
3. Use to press or to set the number of prints for the se
lected image (up to a maximum of 9 for the selected image).
When done, press DISP / OK once again.
4. Repeat Step 2 to select more images for printing or change the
previously specified numbers.
5. Press DISP / OK and follow the rest of the LCD on-screen op
tions to confirm the DPOF setting.
SPECIFYING DPOF OF ALL IMAGES
1. When "All Images" is selected, all images will be set to the same
specified printing number.
2. Use to press or to set the number of prints of all stored
images.
3. Follow the rest of the options to confirm the DPOF setting.
SLIDESHOW
You can play back all images and movies in a slideshow format. The
interval between images can be specified. During the slideshow, press
MENU to stop. From here, you may choose to continue or exit the
current slideshow.
SETTINGS DESCRIPTIONS
Start Slideshow according to the specified
Interval and Repeat options. Start
25
PV100 Eng R7 a OP 9/9/04, 2:45 PM 26