Omega RD200 - Manual (Page 115)

－１１１－
19. HARDWARE CHECK 19.2 Printer Check
This is for checking of trace printing with the cartridge pens and digital data printing with the plotter pen.
1
Example of Printing Check – When the time-axis synchronization (POC) is “off” in 3-pen type
2
Check Flow Chart
Operation screen
[Engineering mode selection]
( + )
3 sec. or more
    
[Selecting check]
    
[Selecting check items]
     
[Selecting printer]
     
[Displaying check]
  
[Executing check]
Digital data printing starts first.
→
Stop checking operation
1. Digital data printing (Plotter pen)
Two lines are printed. The number of
characters per line is 40 with AL and
72 with the AH (repetition of A to Z, 1
to 9 and 0).
2. Trace printing (Cartridge pens)
Each pen prints a sine curve.
(Note)
Even when the time-axis
synchronization is on, printing s
executed in condition of the time-axis
synchronization “off” during printing
check.
* is not accepted during
printing check.
For cancellation of printing check,
press and then press .
By pressing for 2 seconds or
more, the screen returns to the
operation screen, but the printing
disables. For changing the printing to
enable, press and then press
again.
See Reference 1 and Reference 2 in
section 19.1.
2 sec. or more
Cursor Check
Cursor
∗
Types of engineering mode
and check 1
Check printing details
Cancellation of printing check
DISP
SHIFT
6
A - Z
°C °F
ENTRY
DISP
DISP
Cursor
Cursor
(1) (2) (3) (4)
ENTRY
ENTRY
REC
ON/OFF
ENTRY
°C °F
REC
ON/OFF
ENTRY
REC
ON/OFF
ENTRY
Reference
Reference