Omega RD200 - Manual (Page 119)

－１１５－
19. HARDWARE CHECK 19.6 Remote Contacts Input Check
This check is only available for the remote contacts (option). It checks the input signals (shorted or open) at the
remote contacts terminals.
■
Check Flow Chart
Operation screen
[Engineering mode selection]
（ ＋ ）
3 sec. or more
    
[Selecting check]
→
    
[Displaying check 1]
     
[Displaying check 2]
    
[Selecting remote contacts]
    
[Selecting input signal]
   
EX1
EX2
EX3
EX4
Eleven kinds of operations are
available by the remote contacts
signals. The operation allocated to
each terminal (EX1 to EX4) can be
checked.
⇒ See Section 13.2.
Press or to switch
Check 1 and 2.
(1): Alarm output check
(2): Remote contacts input check
(3): Communications interface check
The input signals at EX1 to EX4 are:
0: Open 1: Shorted
2 sec. or more
Cursor
Check
Remote contacts terminals
Remote contacts signals and functions
DISP
SHIFT
6
A - Z
(1) (3) (2) Cursor
Cursor
°C °F ENTRY
% /
°C °F
ENTRY
% /
COM EX1 EX2 EX3 EX4
ENTRY
Cursor
Check 1 and 2 switching Reference 1
Types of check 2 Reference 2
Input signal Reference 3
Ref. 1
Ref. 2
Ref. 3
Cursor