Olympus DS-320 - Manual (Page 10)

10
Replacing Batteries
If begins to flash on the display, stop the
recorder and replace both batteries as soon
as possible.
If [BATT] and
appear on the display, the
recorder will stop and will not operate. Replace
both batteries immediately.
If the recorder fails to work properly after the
batteries are replaced, see “Reset” on page
33.
Warning
• Be sure to stop the recorder before
replacing the batteries. Unloading the
batteries while the recorder is recording,
erasing or otherwise accessing an audio file
may corrupt the file.
• Use only specified batteries with this
recorder.
• Never mix old and new batteries, or
batteries of different types and/or brands.
• Remove the batteries if you are not going
to use the recorder for an extended period
of time.
Using the AC
Adapter
Replacing Batteries/Using the
AC Adapter
Plug in the optional AC adapter (Olympus
Model A321 or A322) into a household power
outlet and connect the power plug to the
recorder’s power connector (DC 3 V) as shown
in the illustration. Do not connect the AC
adapter to the recorder during recording.
Always stop recording before connection.
Otherwise it may not be possible to play back
the voice data being recorded.
Warning
• Stop the recorder before disconnecting
the AC adapter.
• When not using the recorder, always
disconnect the AC adapter from the power
outlet.
• Use only the correct power supply voltage
as indicated on the adapter.
MEN U /VO L
ERA SE SP DIC T
REC ST OP
INDEX/ FOLDER