Onkyo L-DR7 - Manual (Page 119)

119
Operating the TV from Remote Controller
By programming the TV’s remote control code, you can use the RC-506M remote controller to
operate your TV.
■ Programming a TV remote control code
TV/ SETUP TV/ SETUP
DISTANCE DISTANCE UP UP
TV MUTING TV MUTING
TV
POWER
TV
POWER
TV
INPUT
TV
INPUT
DOWN DOWN
TV VOL + TV VOL +
TV VOL - TV VOL -
7 8 9
+10 0 SHIFT
TV CH - TV CH - TV CH + TV CH +
VOLUME
TEST TONE SP SETUP CH SEL
T-D SETUP
ON
7 8 9
STANDBY INPUT SELECTOR
RECEIVER
COND.M LAST M FUNC.M
ANGLE AUDIO SUBTITLE
T-D/ ST LATE NIGHT
TOP MENU MENU
RETURN
DVD
SETUP
REPEAT
TUNING TUNER PRESET
MD / CDR / TAPE
A-B STEP/ SLOW
TIMER
CLEAR
PROGRAM
SEARCH
ACOUSTIC
CONTROL
SURROUND
RANDOM
--/---
MODE
SLEEP
MUTING
DIMMER DISPLAY CLOCK
MODE
1 2 3
4 5 6
2
3
2
4
1
Find the three-digit number for the
brand name of the component you
want to operate in the table on the
next page.
2
While pressing and holding down
TV/SETUP, press ENTER, then
release both buttons.
3
Enter the three-digit remote control
code.
Press the number buttons to enter the code
within 10 seconds. This time, you do not
press RECEIVER. Use only the number
buttons.
4
Make sure that the remote control
code has been programmed cor-
rectly.
Press the remote controller buttons that
control the TV to see if TV responds cor-
rectly.
TV/ SETUP TV/ SETUP
Release the buttons.
You can use these
buttons to control
your TV.
L-DR7_E.book Page 119 Tuesday, December 24, 2002 3:10 PM