Vitek VT-1508 R - Manual (Page 6)

6
ENGLISH
Attention! Do not detach or install the noz-
zle (6) from/at the steam pipe (5) when it
is hot, wait until the steam supply pipe (5)
is cooled down completely (see Pic. 7). You
can wash the nozzle (6) under the water
jet.
How to make tea or to warm up bever-
ages
• Fill the tank (4) with water and install it
into the proper position (see Pic. 1)
• Install filter (8) (the filter should be free
from coffee powder) into the holder (9).
• Put the cup of the appropriate high on the
tray (11).
• Switch the coffee machine on by press-
ing the button (14), and wait until the indi-
cator (12) is deemed.
• Turn the steam supply control handle (3)
upwards, fill the cup with hot water, and
afterwards turn the handle (3) into OFF
position (see Pic. 4).
• You can warm up beverages by steam
going out of the nozzle (5) using instruc-
tions for making cappuccino coffee.
Cleaning
• Cleaning filter (8):
- If the holes of the filter (8) are blocked
with coffee powder deposit, you can
clean it by small brush (see Pic. 8).
• Cleaning the mesh filter installed in-
side the housing of the coffee ma-
chine (at the filter 7 holder installa-
tion place):
- You can remove the coffee powder rem-
nants out of the filter holes by the tooth-
pick.
- Remove the mesh filter if required. Turn
off the fastening screw (a) by a screw-
driver rotating it anticlockwise, detach
the mesh filter (b), and clean the filter
holes by toothpick or needle.
- Second way: remove mesh filter (b) and
immerse it into the vinegar or citric acid
(1/3 tea spoon per one glass of water).
- Install the mesh filter into the proper po-
sition and fasten the screw (a) (see Pic.
9).
• Cleaning the detachable tray for col-
lecting the drops (11):
- When the tray is filled with water com-
pletely, the indicator (10) is lighted. De-
tach the tray (11), remove the grill and
pour the water out.
- Wash the grill and the tray with warm wa-
ter.
- Install the tray into its former position.
Removing the scale
To keep the faultless quality of your coffee
machine operations (specially, in the areas
where the water is hard) it is recommend-
ed to remove the scale periodically by the
citric acid solution (1/3 tea spoon per one
glass of water).
Normal water:
once per 6-8 months
Hard water: once per 6 months
Very hard water: once per 3 months
• Remove the scale from the mesh filter
installed inside the housing of the coffee
machine and put it into the former posi-
tion (see description above).
• Pour the citric acid solution into the water
tank (4).
• Insert the filter (8) into the holder (9) and
install it into the appropriate position (see
Pic. 2).
• Install the appropriate cup on the tray
(11).
• Turn the coffee machine on by the switch-
er (14).
• After the coffee machine has been
warned up turn the steam supply control
handle (3) upwards, fill the cup and turn
the control handle (3) into OFF position.
Pour the liquid out of the cup. Repeat the
procedure several times.
• While the last procedure put the cup un-
der the steam pipe (5) to clean it. Turn
on the steam supply rotating the control
handle (3) downwards. Afterwards turn
the control handle (3) into OFF position.
1508.indd 6 1508.indd 6 15.05.2007 9:57:09 15.05.2007 9:57:09