Olympus CAMERA HOUSING FL-50 - Manual (Page 8)

8/6/2006 8
5. Use & Care of Housing:
5.1 Pre Dive Function Check.
Just before entering the water, make a habit of reviewing that you have carried out the
proper steps to close the housing. and the pressure release plug screwed home. Make a
visual check of the O-ring seal. It is also useful to switch on the camera, and check that
controls e.g. on/off, zoom, shutter functions operate normally. In case of misalignm ent of the
camera, simply open the case and correct the problem.
l
Check housing is closed.
l
Close pressure release plug
l
Check battery is full
l
Check sync cord is connected to the camera housing
l
Shot the camera at Auto mode
If there is a large change of temperature and the housing is not opened for
maintenance between dives, it is recommended to equalize the possible
pressure difference between the inside of the housing and the ambient by
opening the pressure release plug and close it firmly subsequently.
Always avoid submerging the housing in hot water for a prolonged time or a
cleansing tank where the water may be heated up by the sun.
5.2 General Operation.
The control levers and push buttons consist of internal double O-ring seals on a
stainless steel shaft. This arrangement is very reliable, however as a precaution, when
operating the controls, avoid excessively rapid movements, as this may distort the O-ring.
Also please allow for the fact that the camera takes a few seconds to power on. If the camera
dose not appear to respond to a control action, make sure that no other controls are pressing
on the camera, i.e. locking out further actions. Wear the wrist strap; it is easy to
inadvertently let go of the housing, especially if you are distracted.
5.3 Cleaning & Storage.
The body & lid of the housing are made of polycarbonate. Polycarbonate was selected
for its outstanding strength stiffness, hardness and toughness. As well as its crystal clear
transparency and high gloss surface. It has good resistance to weathering, although long-
term exposure to sunlight should be avoided. Normal operating temperature range is 3°C to
36°C (Storage temperature: -10°C to 50°C)