Oregon Scientific RMR613HGA User Manual
Page 7
EN
6
CHANGE SETTINGS
1.
Press and hold MODE for 2 seconds to enter setting
mode.
2.
Press UP or DOWN to change settings.
3.
Press MODE to confirm.
REMOTE SENSOR (THGR122NX)
This product is shipped with a THGR122NX Thermo/
Hygro Sensor that collects Temperature and Humidity
data. Data can be collected from up to 3 sensors.
Additional sensors sold separately.
SETUP SENSOR
Open the remote sensor battery compartment with a
small Phillips screwdriver.
GETTING STARTED
BATTERIES
Batteries are not supplied with this product. You will need
to purchase 2 x UM-3 (AA) 1.5V alkaline batteries for
the main unit, and 2 x UM-4 (AAA) 1.5V alkaline batteries
for the remote sensor.
Insert the batteries before first use, matching the polarity
as shown in the battery compartment. For best results,
install batteries in the remote sensor before the main
unit. Press RESET after each battery change.
Do not use rechargeable batteries.
NOTE
UNIT
LOCATION
Main
Temperature Area when
the INDOOR temperature
is shown.
Remote
Temperature Area when the
OUTDOOR temperature is
shown.
shows when batteries are low.
RMR613HGA lab test R2
1/17/04, 5:00 PM
6