Onkyo TX-NR709 - Manual (Page 83)

83
En
Connection Tips and Video Signal Path
The AV receiver supports several connection formats for compatibility with a wide range of AV equipment. The format
you choose will depend on the formats supported by your components. Use the following sections as a guide.
Video components can be connected by using any one of the following video connection formats: composite video,
S-Video, PC IN (Analog RGB), component video or HDMI, the latter offering the best picture quality.
Tip
• For optimal video performance, THX recommends that video signals pass through the system without upconversion (e.g., component
video input passing through to component video output).
■
“Monitor Out” set to “HDMI Main” or “HDMI Sub”
Video input signals flow through the AV receiver as shown,
with composite video, S-Video, PC IN (Analog RGB) and
component video sources all being upconverted for the
HDMI output. Use these settings if you connect either the
HDMI OUT MAIN or HDMI OUT SUB of the AV receiver
to your TV.
The composite video, S-Video and component video outputs
pass through their respective input signals as they are.
■
“Monitor Out” set to “Both”, “Both(Main)” or “Both(Sub)”
Video input signals flow through the AV receiver as shown,
with composite video, S-Video, PC IN (Analog RGB) and
component video sources all being upconverted for both
HDMI outputs. Use these settings if you connect both the
HDMI OUT MAIN and HDMI OUT SUB of the AV
receiver to your TV.
The composite video, S-Video and component video outputs
pass through their respective input signals as they are.
`
Both: Video signals are output from both HDMI outputs
at the resolution supported by both TVs. You cannot
select “Resolution” setting.
` Both(Main): Video signals are output from both HDMI
outputs but HDMI OUT MAIN takes priority; depending
on the resolution, video signals may not be output from
HDMI OUT SUB.
` Both(Sub): Video signals are output from both HDMI outputs but HDMI OUT SUB takes priority; depending on the
resolution, video signals may not be output from HDMI OUT MAIN.
The on-screen menus appear only on a TV that is connected to the HDMI OUT MAIN. If your TV is connected to
other video outputs, use the AV receiver’s display when changing settings.
Video Connection Formats
IN
MONITOR OUT
Blu-ray Disc/DVD player, etc.
AV receiver
TV, projector, etc.
Video Signal Flow Chart
Composite S-Video Component HDMI
Composite S-Video Component HDMI
PC IN
(Analog RGB)
IN
MONITOR OUT
AV receiver
Composite
Composite S-Video Component
Video Signal Flow Chart
HDMI
HDMI
TV, projector, etc
Blu-ray Disc/DVD player, etc.
S-Video Component PC IN
(Analog RGB)