Programming a macro on a device key, Clearing a macro – One for All URC10820N User Manual

Page 11

Advertising
background image

11

NOTE: When you press POWER for less than 2 seconds, a power
command will only be sent to the currently-selected device. This
allows you to still individually power devices on or off.

2. Devices will turn on (or off) according to your programmed

sequence.

NOTE: The currently-selected device will always turn on or off
first, followed by the remaining programmed sequence. After
the master power sequence has been completed, the remote
control will be set to control the first powered-on device.

NOTE: If one or more devices does not have a POWER key,
the power off/on sequence may be slightly delayed when the
remote control signals the device(s).This action is normal.

Programming A Macro On A Device Key

In its default state, when you press a device key (e.g., TV) on this
remote, the remote will switch to that selected device. However,
you can also program a Macro onto the Device keys to allow for
additional functionality. For example, if your devices are connected
to a receiver unit, you can program a Device macro to switch the
receiver’s input to the selected device.

To Program the Device Key Macro

For example, let’s assume that your DVD in connected to Input
3 of your receiver. You can program a macro that will switch the
receiver’s input to input 3 when you press and hold the DVD key.

1. Press and hold SET until the LED (red light) blinks twice, then

release SET.

2. Enter 9 9 5. The LED will blink twice.
3. Press the DVD key once.
4. Press the AUD key (to select the receiver).
5. Press digit 3 (for the input), and press DVD (to return control to

the DVD key).

6. To save the settings and exit the program, press and hold SET

until the LED blinks twice, then release SET.

NOTE: You can program up to 20 functions on the Device Key Macro.
You can program a device Key Macro onto any device key.

To Operate the Device Key Macro
1. After programming, point the remote control at the receiver

and press the DVD key for at least 2 seconds. This will switch
the Receiver’s input to input 3, to allow you to view the DVD.

NOTE: When you press the device key (e.g., DVD) for less than
2 seconds, the remote will only select the
DVD mode but will
not change the Input on the receiver. This allows you to still
change modes while using the remote.

NOTE: After executing the Device Key Macro, the remote will
return to the
DVD mode, to allow the control of the DVD
device.

Clearing A Macro

1. Press and hold SET until the LED (red light) blinks twice, then

release SET.

2. Enter 9 9 5. The LED will blink twice.
3. Select a macro key (e.g., M1, M2, M3 POWER or any device

key) you want to clear and press it once.

4. Press and hold SET until the LED blinks twice, then release SET.

The macro is now deleted but the keys (in the case of POWER
and device keys), will retain their original function.

Advertising