One for All URC10820N - Manual (Page 8)

8
Using Learning
This remote includes a Learning feature so you can add functions
that are unique to your home entertainment devices (e.g., DVD
EJECT) on the L1 ~ L3 keys. However, there are some considerations.
Learning Precautions
• Your original remote controls must be in working order for
learning to work properly.
• Learned keys are mode specific, so each one can store a unique
function for each mode.
• Learned keys can be used in macros (see “Using Macros”).
• Do not use the following keys for learning: Device Keys, SET,
FAV, or Record (•) Key.
• Learning capacity is approximately 50 to 70 keys, depending on
the code being learned.
• If both learned and keymoved functions are assigned to the
same key, the last programmed function is stored.
• A learned function cannot be used as a source for Keymover
(see “Using Keymover”).
• Certain device codes are not learnable including multi-
frequency types, some high frequency ones, and other unusual
formats.
• For optimum learning, avoid high levels of ambient light such as
natural sunlight or energy-efficient fluorescent lights.
NOTE: Please have your original remote controls handy before
programming learning. Be sure to press each teaching key within
5 seconds of the previous entry. Otherwise, this remote exits the
learning mode.
Programming A Learning Key
1. Press and hold SET until the LED (red light) blinks twice, then
release SET.
2. Enter 9 7 5. The LED will blink twice.
3. Press a device key once (e.g., TV) to assign a mode for learning.
4. Press the desired key once (e.g., L1) to store a feature to be
learned. The LED will turn on and remain on for 5 seconds. If
the LED does not turn on, go back to step 1 and start again.
5. Place your original remote control (e.g., TV remote control)
head-to-head (about 2” apart) from this remote.
6. On your original remote control, press and hold the key (i.e.,
feature) to be learned until the LED on this remote turns off
and then blinks twice. If the LED does not blink twice, repeat
steps 3 through 6.
7. To learn functions onto other learning keys (e.g., L2 and L3),
repeat steps 3 through 6.
8. To lock in new feature(s) on this remote, press and hold SET
until the LED blinks twice, then release SET.
9. To test a learned feature, press a device key (e.g., TV) once
where the learning mode was assigned. Then press the learning
key (e.g., L1) where the learned feature is stored.
Deleting Functions From The Learning Keys
1. Press and hold SET until the LED (red light) blinks twice, then
release SET.
2. Enter 9 7 6. The LED will blink twice.
3. Press the device key once where the learned feature is stored
(e.g., TV).