Olympus VT1621-01 - Manual (Page 25)

23
1
Inserting the lithium battery pack (CR-V3)
Two lithium battery packs are required.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ Caution
• The lithium battery pack CR-V3 cannot be recharged.
1
Make sure the white line on the
power switch is at the OFF
position.
If the power switch is set to ON, move it to
the OFF position.
2
Make sure that the card access
lamp is off.
If the card access lamp is blinking, wait for
it to go off.
3
Raise the battery compartment
knob and turn it to the open
position in the direction of the
arrow as shown in the illustration.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Caution
• If you remove the battery case with the
camera power on, the current mode and time
will be reset. The picture just taken may not be
stored on the card, and images already stored
on the card could be damaged. Please make
sure that the power switch is set to OFF.
Power switch
2
Power switch
1
Card access
lamp
Battery compartment knob
3
ON
OFF
ON
OFF
ON
OFF
Power is OFF. Power is ON.