Onkyo DV-SP302 - Manual (Page 17)

17
Turning On
The DV-SP302 is shipped with the main power (POWER) switch
in the on position (
_ON). When the power cord is plugged in for
the first time, the DV-SP302 will automatically enter the standby
mode and the STANDBY indicator will light (same condition after
step 2 below).
Notes
• Make sure that all appropriate connections have been completed
as described on pages 14 to 16.
• Turning on the DVD Player may cause a momentary power
surge, which might interfere with other electrical equipment
such as computers. To prevent interference, use a wall outlet on
a different circuit.
1
Plug the power cord into the power outlet on
the wall.
2
Press POWER to switch on the main power.
The DVD Player enters standby mode.
The STANDBY indicator lights up.
3
Press STANDBY/ON on the DVD Player or
remote controller.
The DVD Player turns on and the STANDBY indicator
turns off. It takes several seconds to read the disc in the disc
tray.
• To put the DVD Player in the standby mode, press
STANDBY/ON on the DVD Player, or remote
controller.
Notes
• You can turn on the DVD Player by pressing OPEN/
CLOSE 0 or PLAY/PAUSE £/8.
• Setting the STANDBY/ON button to standby does not
shut off the power completely.
• While the STANDBY indicator lights up, the DVD
Player can receive signals from the remote controller.
However, if you press POWER on the DVD Player to
switch off the main power, the remote controller cannot
be used to turn on the DVD Player.
• To switch off the main power, press POWER again.
■ Using DIMMER function
Press DIMMER to change the display brightness.
Each time DIMMER is pressed, the display brightness of the unit
changes as shown below.
Normal
→ Dim → Dimmer → Normal
Connecting the POWER
POWER STANDBY/ON STANDBY indicator
STANDBY/ON