Onkyo DV-SP302 - Manual (Page 18)

18
Basic Playback
Before playing
• Turn on the TV and set the TV to the DVD Player’s input.
• Turn on the audio system and set it to the DVD Player’s input, if an audio
system is connected to the DVD Player.
• DVD video, Video CD, CD, MP3, WMA, and JPEG can be played with
the DVD Player (see “Notes on Discs” on pages 6 to 8). Do not attempt
to play any other types of discs/formats.
About the marks on the pages related to disc operation
means the function or title is related to DVD video operation.
means the function or title is related to Video CD operation.
means the function or title is related to audio CD operation.
means the function or title is related to MP3/WMA sound operation.
Both MP3 and WMA are referred to as MP3 in the following pages.
means the function or title is related to JPEG image operation.
1
Press Open/Close
0.
The disc tray opens. If the DVD Player is in standby mode
when the Open/Close
0 button is pressed, the DVD
Player turns on and the disc tray opens. In this case, it takes
several seconds until the disc tray opens.
2
Place a disc on the disc tray.
Put the disc in the tray with the label side facing up. The
tray has two different disc guide sizes. Place the disc in the
correct guide on the disc tray.
3
Press Play/Pause
£/8.
The disc tray closes and playback starts. The appropriate
disc indicator lights.
For the other information that appears in the display, see
page 11.
If the DVD Player is in standby mode when Play/Pause
£/8 is pressed, the DVD Player turns on and playback
starts. In this case, it takes several seconds until playback
starts.
Tip to obtain a higher quality picture
Occasionally, some picture noise not usually visible during a
normal broadcast may appear on the TV screen while playing a
DVD video because the high resolution pictures on these discs
include a lot of information. While the amount of noise depends
on the TV you use, you should generally adjust the TV to reduce
sharpness when viewing DVD videos.
■ To stop playback
Press Stop
7.
When you press Play/Pause £/8 to restart playback,
playback continues from the location where you stopped playback
because the location index is stored in memory.
For MP3/WMA/JPEG playback, see page 20.
Notes
• The location where playback resumes may vary depending on
the disc or the scene where you stopped.
• Press Stop
7 again after stopping playback to clear the location
index memory, then press Play/Pause
£/8 to start playback
from the beginning.
■ To remove the disc
Press Open/Close
0 to open the disc tray.
Remove the disc after the disc tray opens completely.
After removing the disc, be sure to press the button again to close
the tray.
CAUTION
Keep your fingers well clear of the disc tray as it is closing.
Neglecting to do so may cause serious personal injury.
Starting Playback
Warning
If the DVD Player is connected to the TV or amplifier
through the analog audio jacks, do not play DTS-
encoded discs. Excessive noise may be output from the
analog stereo jacks, which may damage the connected
equipment.
To reproduce DTS surround sounds, digital connection
to an amplifier with a DTS decoder is needed.
DVD
VCD
CD
MP3
JPEG
VCD CD DVD JPEG MP3
Disc tray Open/Close
0
Stop
7 Play/Pause £/8
Skip 4/¢ Search 1/¡