Oregon Scientific WS902 - Manual (Page 4)

EN
INTRODUCTION
NOTE Please keep this manual handy as you use your
new product. It contains practical step-by-step instructions,
as well as technical specifications and warnings you should
know about.
Our body clock is often not in sync with the demands and
rhythm of modern life.
Our biological clock is affected by external cues, such as
sunlight. Light at dawn stimulates production of cortisol,
which gets the body ready to work and wake up. By
simulating dawn, Oregon Scientific’s Sunrise Wake-up Clock
(WS902) prepares the body to wake up by gradually
increasing brightness to the set level in the 20 minutes prior
to desired (set) alarm time.
Start your day better and feel energised to tackle the day.
Wake up as nature intended!
Thank you for selecting the Oregon Scientific Sunrise
Wake-up Clock
TM
IMPORTANT
This device does not reduce the hours
of sleep needed.
OVERVIE
FRONT VIEW
1. Lamp Holder
2. SNOOZE SENSOR: Motion sensor for snooze function
3. / : Adjust volume (only when radio / nature sound
is playing); change values of the setting
4. SLEEP: View remaining time; enable sleep function
with radio / nature sound / light; set sleep timer
5. RADIO TUNE : Enable auto-search for radio station;
adjust radio frequency marginally (by 0.05MHz)
6. NATURE SOUND: Toggle through selection (Crickets /
Brook / Ocean / Rain)
7. SET CLOCK: Enter clock settings
8. SET ALARM: View alarm status; enter alarm settings
9. / : Adjust brightness (only when LAMP function
has been activated)
10. LAMP: Turn on/off light
11. ALARM: Enable / disable alarm function
12. RADIO: Turn on / off radio
9
10
11
12
BOTTOM VIEW
1. Battery compartment
2. WAKE UP LIGHT ON•OFF: Enable / disable light for
alarm sequence
3. DISPLAY BRIGHTNESS LOW•HIGH: Select LCD
display brightness LOW / HIGH
4. AUDIO LINE-IN: Socket for connecting to external
music storage device
5. RESET: Reset unit to default settings
REPLACING LAMP
LCD DISPLAY
1. AM/PM
2. Beep / Radio / Bird chirp alarm selected
3. Alarm with wake up light enabled
4. Batteries low / no battery
5. Alarm time
6. Radio Mode is ON and frequency is displayed
7. Volume is displayed
8. Sleep mode is ON and remaining time is displayed
9. Nature sound selected (1-4)
10. Sound from external source plugged into unit
For first time use, take out provided light bulb and go
directly to step 2.
1. Unplug unit from wall socket and allow unit (bulb) to
cool for approx. 15 minutes.
CAUTION Always allow unit to cool for 15 minutes prior
to cleaning, storing, replacing parts as unit can be very
hot.
2. Turn the unit around to view back of the product
( UNLOCK COVER tab facing you)
3. Using left thumb, press and hold UNLOCK COVER
tab.
GETTING STARTED
1
2
3
4
5
6
7
8
1 & 5 3
2
4
2
1
2
3
4
5 6 7 8 9
10
11