Oregon Scientific WS902 - Manual (Page 6)

LCD BACKLIGHT
RESET
ALARM WITH WAKE UP LIGHT
To activate / deactivate wake up light:
• Slide WAKE UP LIGHT switch to ON / OFF.
When wake up light has been activated, will be displayed
next to ALARM on the LCD screen.
NOTE Light will fade-in (gradually increase in brightness
to maximum) 20 minutes prior to set alarm time. Light Will
stay on (even after SNOOZE has been activated) after
set alarm time for 60 minutes.
SLEEP TIMER
To adjust sleep timer setting:
1. Turn on desired option:
OPTION PRESS:
Radio RADIO
Light LAMP
Nature sound NATURE SOUND
2. Press SLEEP to activate.
3. Press SLEEP repeatedly to change the sleep timer
setting (120, 90, 60, 30, 15, 0 min).
After 5 seconds of inaction, the timer will automatically be
confirmed and set.
TIP Press SLEEP again to change sleep timer (120, 90,
60, 30, 15, 0 min).
NOTE Ensure radio or sound and/or light has been
selected to activate sleep timer.
NOTE If light option has been chosen for sleep timer, light
will fade out.
READING LAMP
To turn on / off light:
• Press LAMP.
To adjust level of brightness:
• Press / to increase or decrease brightness.
TIP Press and hold / to rapidly change level of
brightness (1-20).
For your convenience, the level of brightness will be
stored in memory for the next time reading lamp is turned
on.
NOTE Do not look directly at the light.
PLAYING MUSIC
Using a cable, plug one end to your music storage device
and one end to AUDIO LINE-IN located at the back of unit.
When cable has been successfully connected, will
be displayed on the LCD screen and sound will emit from
speakers.
To adjust brightness:
• Slide DISPLAY BRIGHTNESS switch to LOW / HIGH.
1. Remove and reinsert the batteries.
2. Press RESET to return to the default settings.
SPECIFICATIONS
DESCRIPTION
257 x 199 x 140 mm
(10.12 x 7.84 x 5.51 in)
87.5 to 108 MHz
Input: AC 230V 50Hz
(EU version)
Input: AC 100-120V 50/60Hz
(US/Canada/Japan version)
2 x UM-4 (AAA) 1.5V batteries
(for backup)
TYPE
MAIN UNIT
L x W x H
FM
Power
Weight 386 g (13.6 oz) without battery
4
EN
• Connection type of the switch:
ε
• Range of lamp load: (Lamp) 20W - 60W
• The apparatus shall not be exposed to dripping or
splashing.
• To be completely disconnect the power input, the
mains plug of apparatus shall be disconnected from
the mains.
• The mains plug of apparatus should not be
obstructed OR should be easily accessed during
intended use.
• No naked flame sources such as lighted candles
should be placed on the apparatus.
NOTE