Oricom M5500 Series - Manual (Page 15)

13
BASIC OPERATION
Take two different calls at the same time
During a call, you will hear two loud beeps periodically to notify you of another incoming
call. If you wish to answer this call,
1
. Press R key. You will hear a dial tone.
2
. Press 2 to put the current call on hold and talk with the second caller.
3
. Repeat steps 1-2 to swap between the two callers.
Recall settings are: Australia (100ms, SHORT); New Zealand (600ms, LONG).
If this feature does not work correctly, check the country option. To change the Recall
settings, press and hold
/P key on the cordless handset to switch between “LONG”
and “SHORT” on the display.
Recall function when connected to a PABX
If you have connected your telephone to a PABX, you can use all the facilities such as
call transfer, automatic recall, etc. The R key provides access to these facilities.
Recall feature
Recall feature can be used when you are using some services provided by your
network operators such as “call waiting”, etc. A subscription may apply for these
services, contact your network operators for more information.
While you are talking on the phone, press R key on the base unit or  /R key on
the cordless handset to send a Recall (flash signal).
Call waiting
You can use the recall function to answer a second call while you are on the phone.
However this service need to be turned on. For example, to turn on Telstra’s Call Waiting
service:
1
. Press on the base unit or on the cordless handset to wait for dial tone
then press 4 3 # .
2
. You will hear a service tone then press or mentioned above.