Oregon Scientific Radio-Controlled Projection Clock with FM Radio RRM310P - Manual (Page 5)

5
EN
To scroll through preset stations:
Press repeatedly.
SLEEP
The radio is equipped with a countdown sleep timer
that can be set to switch the radio off after up to 120
minutes.
1. Press to enter sleep mode.
2. Press to change the sleep time setting (120,
90, 60, 45, 30, 15, 0).
3. Press any key to exit sleep mode – the sleep timer
will be automatically activated.
BACKLIGHT
Press SNOOZE / LIGHT to activate the backlight for
8 seconds.
ALARM
Press to view the alarm display.
To set the buzzer or radio alarm:
1. Press and hold
for 2 seconds.
2. Use to change the setting.
3. Press to confirm the setting and move onto the
next one.
4. The setting sequence is: Hour, minute, alarm type
(i.e. radio alarm or buzzer alarm).
5. If radio alarm is selected, preset station and preset
volume can also be altered.
6. Press to exit alarm setting mode.
NOTE If the radio alarm time is reached when the
adapter is not connected the unit will default to buzzer
alarm.
To activate / deactivate the alarm:
Press
. The respective alarm icon appears when the
alarm has been activated.
To silence the alarm:
• Press SNOOZE / LIGHT to silence it for 8 minutes.
The buzzer alarm or radio alarm icon will flash to
show snooze is enabled.
OR
• Press and hold SNOOZE / LIGHT to turn off the
snooze function and reset the alarm for 24 hours
time.
OR
• Press any key except SNOOZE / LIGHT to mute
any alarm and activate it again in 24 hours.
NOTE The radio will remain on for 120 minutes if no
key is pressed.
PROJECTION UNIT
The projection unit can display both time and alarm
status. To use this feature:
• Slide the PROJ. ON switch to ON to activate
continuous projection. However, this function will
not work unless the adapter is used.