Onkyo DR-L50 - Manual (Page 19)

19
AC INLET PREOUT
SUB
WOOFER TV/LINE MD/CDR/TAPE
DIGITAL
OPTICAL
VIDEO OUTPUT
AUDIO
REMOTE
CONTROL
AM FM 75
SURROUND
SPEAKERS FRONT SPEAKERS
R L
S VIDEO VIDEO IN
IN IN OUT
L
R
R L
OUT
AV CONNECTOR
ANTENNA
S VIDEO
IN
DIGITAL
OUT
OPTICAL
VIDEO
IN
AUDIO
OUT
R
L
AV
CONNECTOR
Connecting to a TV (European model)
Before connecting
• Refer also to the instruction manual of the TV.
• When you connect the DVD Receiver to the TV, be sure to turn
off the power and unplug both the units from the plugs before
making any connections.
• Connect the DVD Receiver to the TV directly. If you connect the
DVD Receiver to a VCR, TV/VCR combination, or video selector,
the playback picture may be distorted as DVD videos are copy
protected.
• Connect the plugs securely.
Incomplete
Insert completely
■ Connecting to a TV Using the SCART Cable
Connect the DVD Receiver and your TV using the supplied SCART cable.
If the TV is compatible with S video signals
After completing the steps on page 19, set “Video Out” to “S-Video” using the menu
explained in “Customizing the Function Settings” starting from page 68. See page 71 for
direct information.
If an RGB monitor is connected to the DVD Receiver
After completing the steps on page 19, set “Video Out” to “RGB” using the menu explained
in “Customizing the Function Settings” starting from page 68. See page 71 for direct
information.
■ Connecting to a TV using the Audio/Video
connection cable or S video connection cable
If the TV or monitor does not has an AV CONNECTOR input
terminal, make video connection using audio/video connection
cable.
If your TV has an S video input jack, make the S video
connection. The S video connection will provide highter quality
picture playback. You can switch between [S1] and [S2] S-video
output from the Setup menu on page 71.
TV or projector
SCART cable
To AV CONNECTOR
input terminal
TV or projector
L (White)
R (Red)
Video
(Yellow)
S video connection cable
Audio/video
connection cable
Signal flow
See “Turning the unit on/off with the TV’s power
switch — IPM function” on page 27 for Intelligent
Power Management (IPM) function.
DO NOT connect the
power cord at this time.
Optical fiber cable
Use the DIGITAL OPTICAL
IN jack in combination with
the TV/LINE IN jack. When
you use the Input selector
to select TV/LINE IN,
DIGITAL OPTICAL IN is
also activated. When both a
digital signal and an analog
signal are input, the digital
signal takes precedence.