Onkyo DR-L50 - Manual (Page 28)

28 28
Speaker Setup
You need to set up the speaker configuration for the speaker
system connected to the SPEAKERS connectors (see page
20.)
Notes
• Speaker setup cannot be done if;
– Headphones are connected (see page 42)
• It is not necessary to set the parameters again once you have
completed the setup unless you change the speaker
configuration.
Selecting the number of speaker
channels
→
Press SP SETUP repeatedly to
select the number of channels for
the SPEAKERS system.
Pressing the button repeatedly within three
seconds changes the number of channels
as follows (the corresponding speaker
configuration is described in parentheses):
Speaker 2 ch (Factory setting)
(Front left and right speakers)
↓
Speaker 3 ch
(Front left, center, and right speakers)
↓
Speaker 4 ch
(Front left and right, plus surround left
and right speakers)
↓
Speaker 5 ch
(Front left, center, and right, plus
surround left and right speakers)
The normal display resumes in three
seconds.
Note
To check the present setting while the normal display is displayed,
press SP SETUP once. To change the setting, press the button
repeatedly within three seconds.
Remote controller
only
SP SETUP
LAST M
1
TV/ SETUP TV/ SETUP
TEST TONE SP SETUP CH SEL
DISTANCE SW MODE UP
TV MUTING
TV
POWER
TV
INPUT
T-D SETUP IPM DOWN
TV VOL +
TV VOL -
9
TV CH - TV CH +
VOLUME
ON
STANDBY INPUT SELECTOR
RECEIVER
COND.M LAST M FUNC.M
ANGLE AUDIO SUBTITLE
T-D/ ST LATE NIGHT
TOP MENU MENU
RETURN DVD SETUP
REPEAT
TUNING TUNER PRESET
MD / CDR / TAPE
A-B STEP/ SLOW
TIMER
CLEAR
PROGRAM
SEARCH
ACOUSTIC
CONTROL
SURROUND
RANDOM
--/---
MODE
SLEEP
MUTING
DIMMER DISPLAY CLOCK
MODE
+10 0 SHIFT
9
4 5 6
7 8
1 2 3
SW MODE
SP SETUP
→
Selecting the Subwoofer mode
Before operating the
remote controller
Press MODE TV/SETUP.
Press SW MODE on the remote
controller.
With the first press of the button, you can
check the present setting. Then each
press of the button changes the subwoofer
mode as follows (a tip on how to select the
right subwoofer mode is in parentheses):
SW Mode 2 (Factory setting)
(When large–wideband–front speakers
are connected)
↓
SW Mode 3
(When large–wideband speakers are
connected to all channel)
↓
SW Off
(When no subwoofer is connected)
↓
SW Mode 1
(When small–with limited bass signal
handling–front speakers are
connected)
The normal display resumes in three
seconds.
Remote controller
only
SW MODE
AUDIO
4