Oregon Scientific Travel Radio-Controlled Projection Clock RM888PA - Manual (Page 7)

7
GB
12. Press [MODE] to save the changes and exit. If changes are
made during the process, the seconds will reset and start from
zero.
The unit will also save all changes and return to normal display
automatically after the unit has been left idle for a minute or when
[ALARM] is pressed.
ABOUT THE ALARM
To set the alarm,
1. Press [ALARM] to enter the Alarm mode.
2. Press and hold [ALARM] for 2 seconds.
3. Use [▲]/[▼] to enter the hours.
4. Press [ALARM].
5. Use [▲]/[▼] to enter the minutes.
6. Press [ALARM].
The alarm will be automatically activated. The icon will appear
on the digital display and the Alarm-on icon will be displayed on
the analog display. To deactivate the alarm, press [▲]/[▼] when
the alarm time is displayed.
HOW TO USE THE DAILY ALARM
The alarm will go off for 2 minutes in a two-step crescendo pattern.
The alarm-on indicators will flash, the back-light and the clock
projection will be activated for 5 seconds. To mute the alarm, press
any key. Pressing [SNOOZE/ ] will activate the snooze function.
SNOOZE FUNCTION
When the snooze function is activated, the alarm will be muted
temporarily and set off again after 8 minutes. To disable the snooze
function, press [ALARM].
SECTION 3
ADDITIONAL INFORMATION
THE RESET BUTTON
The [RESET] button is used to enhance synchronization of signals
after battery replacement or when the unit is operating in an
unfavorable way or malfunctioning. Use a blunt stylus to hold down
the button. All settings will return to their default values.
PRECAUTIONS
This product is engineered to give you years of satisfactory
service if you handle it carefully. Here are a few precautions: