Omega Vehicle Security OMEGAFLEX FPU500 - Manual (Page 26)

Operating the Pump 5
5-3
1. Refer to Figure 5-1 and Figure D. Snap open the Stator (1) by
pushing the spring-loaded area of the Latch (2). Remove any old
tubing from the pump, if necessary.
2. Refer to Figure 5-2 and Figure D. Loop the Tubing (10) over the
rollers. This is easy to do even for stacked pumps.
Tubing can be changed on stacked pumps without
detaching either of the pumps from the motor.
3. Refer to Figure 5-3. Push the stator closed until you hear the latch
engage.
4. Refer to Figure 5-4. Tighten the Clamp Screw (4) until the Clamp
Plate (3) contacts the tubing, securing it in place.
Parts of the Pump
Figure D
1
4
2
(Clamp Screw)
(Stator)
(Latch)
10
(Tubing)
3
(Clamp Plate)
NOTE