Omega Speaker Systems Rercorder RD8300 - Manual (Page 52)

Section 5 – Recorder Setup
Page 43
09/11/2008 REV 0.99
Test Dialog: This window enables you to test your
calculation after the recorder has compiled it. The
original calculation is shown in the top line. There
are entry boxes to enable you to set actual values for
the channel variables. Once you have entered data,
pressing the Calculate button will display the
answer in the line above it. This test dialog
can also be used to evaluate functions or
any other expression entered.
If the answer is as expected or you need to go back
and alter the formula press the Exit button.
MIN MAX AVG RESET: If the Min, Max or Avg
function is used in an equation, upon exit you will
get the Min, Max, Avg Reset Dialog window shown
right. This enables the Min, Max or Avg values to
be reset periodically, upon an external event or
upon an alarm event.
Auto Reset Enable: If this box is unchecked the
Min, Max, Avg will calculate continuously unless
External Reset Enable is checked. If the Auto
Reset Enable box is checked then the values will
reset at the Reset Interval.
Ext. Reset Enable: This is the External Reset
enable. If this box is checked the max, min, avg
values will be reset by an external event via the
digital inputs
Note: an optional digital I/O card must
be present in the system AND the designated input
must be input is
enabled . The digital input needs to be programmed as a MinMaxAvg type.
Reset Intrvl: This is the Reset Interval. This is the time in days, hours, minutes and seconds between
timer resets when Auto Reset is checked. In the example th min, max oravg will be reset every 5 minutes.
Reset Sync: If the Sync Enabled checkbox the max, min or avg will reset the first time it reaches the
set time. This allows the user to synchronize the reset to a known time. This also allows several channels
to be synchronized together if the Reset Sync time is set to the same for all. This time is ignored if the
enable box is not checked.
Reset Print: When this box is checked the max, min avg reset information will be appended to the
alarm/event log each time the values reset.
Power Up Reset: When this box is checked the value (max, min or avg) will be reset on power up,
otherwise it will continue from the last value saved before power down.
Reset on Alarm – If Alm Reset Enable is checked the Min, Max,
Avg values will be reset by the Alarm condition selected. In this
case when Channel 1 Alarm 1 is active.
Figure 5-6 Test Dialog Window
Figure 5-7 Min Max Avg Reset Setup