Registry – Omega Speaker Systems Rercorder RD8300 User Manual
Page 86
Section 5
– Recorder Setup
Page 77
09/11/2008 REV 0.99
5.7.8 SMTP Email Settings
This allows the administrator to set up the email.
This feature is entered from the
by pressing the icon shown right
SMTP is Simple Mail Transfer Protocol and is the standard
for email transmission across the Internet. The defaults for
emails are set here as follows:
From: The default n
ame that will appear in the “From” field of
the email that is sent. It needs to be a real email address.
To: The default address of the recipient that the email will be
sent to.
SMTP IP address: This is the address of the SMTP mail
server that the email will be sent to so that it can be rerouted
to the recipient. It can be an address like 192.168.0.104 or it
can be the name of the server. A working example of this is smtp.unlimitedmail.org. This is an email
forwarder and you can use this if you do not have anything else to use or have problems with your internal
servers.
SMTP user id: This is the user id needed to authenticate to the mail server. If you are going to use the smtp
address smtp.unlimitedmail.org, you will need to setup an account at www.unlimitedmail.org.
SMTP password: This is the user password needed to authenticate to the mail server.
Once the changes have been made press the accept button
to exit or the cancel button
to
quit without saving the changes.
5.7.9 Set ActiveSync Password
This allows the administrator to set up the password for allowing PC to USB on the recorder,
connection via Activesync. This feature is entered from the
shown right
The unit can be synched to a PC via the USB B Slave port
using ActiveSync
– see
. There is no
username, but a password needs to be entered in order to
make the connection. Enter the password as shown here
and check the enable checkbox.
Once the changes have been made press the accept
button
to exit or the cancel button
to quit
without saving the changes.
Note: These changes will be in effect the next time you
restart the unit. It is necessary to
and restart the unit (you can, with caution use the
Figure 5-26 System Setup
Fig 5.7.9
– USB ActiveSync Password