One for All 6-Device Universal Remote - Manual (Page 13)

O NE F OR A LL 6L U NIVERSAL R EMOTE C ONTROL WITH L EARNING
12 Programming Favorite Channel Scan
3. To stop scanning channels at any time,
press any key once.
PROGRAMMING FAVORITE
CHANNEL SCAN
In the TV, VCR, DVD or CBL/SAT mode, you
can store a list of up to 10 favorite channels,
in any order, that will be immediately
scanned when you press FAV (see “Using
Channel Scan” on page 11).
NOTE: Only channels of one mode can be
stored for Favorite Channel Scan.
1. On the remote control, press TV, VCR,
DVD or CBL/SAT once.
2. Press and hold SET until the LED (red
light) blinks twice, then release SET.
3. Enter 9 9 6. The LED will blink twice.
4. Use the keypad to enter a favorite
channel number (e.g., 031). Then press
SET once.
NOTE: If the original remote control required
pressing an ENTER key to change the channel,
also press the ENTER key after the channel
number (e.g., 0 3 1 ENTER).
5. If desired, repeat step 4 (in this
section) for each favorite channel to be
stored, up to a total of 10 channels.
NOTE: If you try entering more than 10
channels, the remote control will
automatically exit programming.
6. To exit programming, press and hold
SET for 3 seconds. The LED will blink
twice.
USING LEARNING
The One For All 6L Universal Remote
Control with Learning (URC-6820 B00)
includes a Learning feature so you can add
functions that are unique to your home
entertainment devices (e.g., DVD EJECT).
However, there are some considerations.
L EARNING P RECAUTIONS
• Your original remote controls must be
in working order for learning to work
properly.
• Learned keys are mode specific, so
each one can store a unique function
for each mode.
• Learned keys can be used in macros
(see “Using Macros” on page 9).
• Do not use the following keys for
learning: Device Keys, SETUP, FAV, or
Record (•) Key.
• Learning capacity is approximately 50
to 70 keys, depending on the code
being learned.
• If both learned and keymoved
functions are assigned to the same key,
the last programmed function is
stored.
• A learned function cannot be used as a
source for Keymover (see “Using
Keymover” on page 14).
• Certain device codes are not learnable
including multi-frequency types, some
high frequency ones, and other
unusual formats.
• For optimum learning, avoid high
levels of ambient light such as natural
sunlight or energy-efficient fluorescent
lights.
NOTE: Please have your original remote
controls handy before programming learning.
Be sure to press each teaching key within 5
seconds of the previous entry. Otherwise, the
One For All 6L Universal Remote Control with
OFA 6L with Learning Owners Manual.fm Page 12 Thursday, February 17, 2005 1:10 PM