One for All 6-Device Universal Remote - Manual (Page 18)

O WNER ’ S M ANUAL
Troubleshooting 17
SOLUTION: Make sure the remote
control is aimed at your
home entertainment
device and is not farther
than 15 feet away.
PROBLEM: The unit does not control
home entertainment
devices or commands are
not working properly.
SOLUTION: Try all listed codes for the
device brands being set
up. Make sure they can be
operated with an infrared
remote control.
PROBLEM: TV/VCR Combo does not
respond properly.
SOLUTION: Use the VCR codes for your
brand. Some combo units
may require both a TV code
and a VCR code for full
operation.
PROBLEM: Changing channels does
not work properly.
SOLUTION: If the original remote
control required pressing
ENTER to change channels,
then press ENTER on the
remote control after
entering the channel
number.
PROBLEM: During learning, LED
emits a long blink after
pressing and holding key
to be learned.
SOLUTION: Memory is full or a bad
capture has occurred.
Avoid high-ambient light
sources, such as direct
daylight and fluorescent
bulbs. Try readjusting
positions of remote
controls before performing
the procedure again.
PROBLEM: Tried Searching For Your
Code method and still
could not find a working
code.
SOLUTION: Clear the device key as
follows: Press and hold SET
until the LED (red light)
blinks twice, then
release.Next enter 9 9 2.
Then press the device key
to be cleared twice.Now
repeat the Searching for
Your Code method on page
8.
PROBLEM: CH+ and CH- do not work
for your RCA TV.
SOLUTION: Due to RCA design (1983-
1987), only the original
remote control will operate
these functions.
PROBLEM: No remote control of
volume.
SOLUTION: See “Changing Volume
Lock” on page 15 to lock/
unlock volume.
OFA 6L with Learning Owners Manual.fm Page 17 Thursday, February 17, 2005 1:10 PM