Mounting the ppo-e05 on the waterproof case – Olympus PPO-E05 User Manual
Page 12
EN 3
En
2. Mounting the PPO-E05 on the Waterproof Case
This section describes how to mount this product on the PT-E series case. Before mounting, check that
no foreign matter is attached to the O-rings, the port mount thread on the PT-E series case, or the O-
ring contact surfaces. Apply a thin layer of the provided silicone O-ring grease.
1
Align the threaded section of the PPO-E05 with the port mount
thread on the PT-E series case.
2
Hold the PT-E series case firmly with one hand, hold the main
body of the PPO-E05 with your other hand and screw it into the
PT-E series by turning the PPO-E05 clockwise.
3
Resistance increases as the PPO- E05 is screwed in more
deeply. However, be sure to screw it in all the way until there
is no gap visible below the threaded section of the PPO-E05.
Threaded section
O-ring
O-ring contact surfaces
Port mount thread
Grease applying surface on O-rings
Screw in until there
is no gap.
PPO-E05_EN-01.fm Page 3 Tuesday, March 20, 2007 6:55 PM