Omega TX82B - Manual (Page 9)

3.3 INSTALLATION/REMOVAL
The TX82B is housed in a 1/8 DIN case. The electronic circuitry can be installed or
removed from the front and is attached to the case with two M4 screws through the
rear panel.
Panel Mounting
1. Remove the two thumbnuts on the rear of the case.
2. Slide the sleeve off the case (see Figure 3-1 Exploded View).
3. Verify the panel cutout dimensions in Figure 3-2 Case Dimensions. Insert the
case in the panel cutout from the front and slide the sleeve on from the rear.
Install the two thumbnuts to secure the sleeve to the case.
Main Board Access:
1. Case must be removed from sleeve.
2. Remove lens from case.
3. Slide main board from front of case.
Figure 3-1 Exploded View (includes rear panel)
5
SLEEVE
THUMBNUT
CONFIGURATION LABEL
(BACK SIDE OF DISPLAY BOARD)
THREADED STUD
REAR PANEL
MAIN BOARD
DISPLAY
BOARD
FRONT LENS
ELECTROSTATIC RISK
DO NOT RUN OR
CLEAN WITH SOLVENT
J3 B
REAR CONNECTOR (P3)
FOR SIGNAL INPUT
1 2 3
ID. LABEL
CASE
PANEL