Optimus 32-3009 - Manual (Page 16)

16
3. Press CUE ASSIGN for the second
input source.
4. Set the input source selector to
the input source you want to mon-
itor.
5. Start playback of the input source
you want to play next through your
sound system.
6. If necessary:
• Adjust CUE LEVEL to a comfort-
able listening level.
• Adjust the second input source
volume slide control to the cor-
rect preset position.
7. Set the input device to the desired
section of music, then stop or
pause the input device.
Switching to the Second
Input Source
1. Start playback of the second input
source.
2. When you are ready to play its
sound through your sound sys-
illustration of CUE
ASSIGN with arrow to
CH 2
illustration
tem, slide CROSS FADER from A
to B .
Slide CROSS FADER :
• To the left to fade in the channel
selected by ASSIGN A and fade
out the channel selected by AS-
SIGN B .
• To the right to fade in the chan-
nel selected by ASSIGN B and
fade out the channel selected
by
ASSIGN A .
• To the center to equally mix the
two.
Notes on Mixing
• If you set CROSS FADER to A to
play the channel selected by AS-
SIGN A , then you must set CUE
ASSIGN to CH 1 to monitor CH 1 , to
CH 2 to monitor CH 2 , to CH 3 to
monitor CH 3 , to CH 4 to monitor
CH 4 , and to MIC to monitor DJ
MIC . The same applies when you
set CROSS FADER to B.
• To mix any two inputs selected by
the ASSIGN switches, set each
ASSIGN switch to the desired
channel. Then use
CROSS FADER
to mix the two.
illustration of CROSS
FADER w/arrow
from A to B
32-3009.fm Page 16 Tuesday, August 10, 1999 8:31 AM