Optimus 32-3009 - Manual (Page 17)

17
• Do not slide CROSS FADER to the
center if you want to monitor one
channel while the other is playing.
Otherwise, the sound from the
channel you monitor will also be
heard through your sound system.
Instead, slide
CROSS FADER to
the channel you are not monitor-
ing. For example, to monitor chan-
nel 1 (selected by
ASSIGN A )
while channel 2 (selected by AS-
SIGN B ) is playing, slide CROSS
FADER to B .
• Use CUE/PGM to listen to the input
controlled by the CUE ASSIGN
switch and what is playing on the
currently selected output device.
When
CUE/PGM is set to CUE , you
only hear the channel selected by
the
CUE ASSIGN switches. When
CUE/PGM is set to PGM , you only
hear what is playing on the cur-
rently selected output device. Ro-
tate
CUE/PGM to listen to both
inputs at the same time.
USING TALKOVER
When you are not using the micro-
phone, leave
OFF/ON/TALKOVER set
to OFF. The microphone’s input is
turned off and all other audio input
sources are unaffected.
If you want to use a microphone:
• Set OFF/ON/TALKOVER to ON to
mix the microphone equally with
the other audio input sources.
• Set OFF/ON/TALKOVER to TALK-
OVER to mix the microphone at a
higher level than the other audio
input sources.
Your voice sounds clearly through
the microphone, but all the other
audio input sources sound at a
lower level. (This is useful for pag-
ing.)
illustration of switch
set to TALKOVER
32-3009.fm Page 17 Tuesday, August 10, 1999 8:31 AM