Omega RD100B - Manual (Page 78)

4-1
Common Operations for Setting Functions and Setup Guide
4
4.1 Run Modes
The recorder has three run modes.
Operation Mode
This mode is used for normal recording operation. The recorder enters this mode when
the power is turned ON. The operations that can be carried out in this mode are
described in chapter 3. The details on the data display setup screen are explained in
chapter 8.
Setting Mode
This mode is used to set the input range, alarms, chart speed, and other parameters.
These settings can be changed while recording is in progress. However, the input range
of measurement channels and the computing equation, unit, constant, and TLOG setting
of computation channels cannot be changed while computation (/M1 option) is in
progress. The operations that can be carried out in this mode are described in chapter 5
and 6.
Basic Setting Mode
This mode is used to set the basic specifications of the recorder such as the
thermocouple burnout detection function and the alarm output relay operation. This
mode cannot be entered while the recorder is recording or while computation is in
progress on the computation function (/M1 option). Measurement, recording, and alarm
detection cannot be carried out in this mode. The operations that can be carried out in
this mode are described in chapter 7.
Operation mode
Power ON
Setting mode
Data display setup screen
Basic Setting mode
MENU 1
Display “End=Store” and press
MENU
Hold down
for 3 s
Hold down
Hold down
+ for 3 s
for 3 s
Chapter 4 Common Operations for Setting Functions and Setup Guide