Olympus C-2020ZOOM - Manual (Page 32)

32
BASIC OPERATING PROCEDURE
Remove the lens cap.
Set the Mode dial to P, A/S/M,
or to turn on the
power.
• A/S/M, P and
set the
camera to the Record mode.
The lens will come out and the
remaining battery power as
well as the number of storable
pictures will be displayed on
the control panel.
• sets the camera to the
Display mode. The LCD
monitor will be turned on.
After use, set the Mode dial to
OFF to turn off the power.
• The lens will retract and the
display on the LCD monitor
and the control panel will
disappear.
3
2
1
PO
W
E
R
/ M
O
D
E
D
I AL
P
A/S/M
OFF
P
A/S/M
OFF
POWER
/M
O
D
E
D
IA
L
2
1
Note:
• Do not turn on the power without removing the lens cap first.
• NEVER open the card cover, eject the card, remove the batteries, or pull
the plug while the camera is in operation. It may destroy the data in the
card.
• If you do not operate the camera for three minutes, the camera will be
set to the stand-by mode. After four hours in the stand-by mode, the
power turns off automatically. (Time varies depending on the type of
batteries used.)
• The recorded images will remain in the card even after the power is
turned off or the batteries are replaced.
3