Olympus C-2020ZOOM - Manual (Page 70)

70
TAKING A PICTURE USING THE REMOTE
CONTROL
Compose the picture, aim the
remote control at the Remote
control window on the
camera, then press the
Shutter release button on the
remote control to take a
picture.
• The Selftimer/Remote control
signal blinks for approx. 3
seconds before the picture is
taken. If the signal does not
blink when the Shutter release
button is pressed, move closer
to the camera and press it
again. The signal does not
light when there is frequency
interference. In such a case,
change the frequency
according to the remote
control instructions.
• See page 102 for using the
Remote control in the Display
mode.
15
° 15
°
3m
3m
5m
Remote control window
Selftimer/Remote
control signal
Note:
• The Selftimer/Remote control mode will remain after a picture is taken
using the Remote control.
• The working distance may be reduced in brightly lit areas, such as under
direct sunlight.
• Do not subject the Remote control window to bright light.
• When the remote control is not operated for approx. 3 minutes, the
Selftimer/Remote control mode will be canceled.