Olympus C-3000ZOOM - Manual (Page 75)

75
Note:
• The main flash cannot be used in the Sequence mode.
• When using an extension flash, set the speed fast enough to follow the
sequential shooting.
• Since the LCD monitor’s picture blacks out while taking pictures in the
Sequence mode, use the viewfinder to take pictures in this mode.
• Unless OFF is selected in All Reset, the setting will be canceled when the
power is turned off. (p. 194)
• This mode cannot be used in the TIFF/SHQ recording mode.
• Since the slowest shutter speed in the Sequence mode is set to 1/30
second to prevent camera movement, the resulting picture may be darker
than expected.
• Sequential shooting will continue for as long as the Shutter release button
is held down. When the Shutter release button is released, Sequential
shooting stops.
• Even if the Sequence mode is switched to another mode after taking
sequential pictures, it will not be possible to take another picture until
recording in the card finishes.
• The speed will be slower with AF .
The available sequential shutter speeds and number of pictures that can
be taken depend on the selected recording mode. Refer to the table
below when using the sequential mode.
TIFF
2048 X 1536
2048 X 1536
1600 X 1200
1280 X 960
SHQ
HQ
SQ1
1024 X 768
640 X 480
SQ2
Recording mode
Number of pixels
Sequential shutter speed
(approx. frames/sec.)
Number of
pictures
Not available
Not available Entire
5
1.2
~
1.8
3
7
5
11
6
18
15
38
HIGH (High quality)
NORMAL
HIGH (High quality)
NORMAL
HIGH (High quality)
NORMAL
HIGH (High quality)
NORMAL
Number of Still Pictures that can be Taken in Sequence mode
The numbers above are valid when the LCD monitor is set to OFF.