Oki B 2400 - Manual (Page 21)

Diagnostic Information 2-3
24xx
Power
Ready
Paper Out
Panel Lock
Font Lock ON
Blinking
Blinking
Blinking
Blinking Beeps
10
times Home Position Error
Go to “Carrier Service Check”
on page 2-16 .
Tractor 2 Home Position Error
If Tractor 2 is installed, remove it
to determine whether the problem
is with the carrier home position
sensor or the Tractor 2 home
position sensor. See the
“Tractor
2 Service Check” on page 2-33 .
None Home Position Error Without
Alarm
Go to “Power Service Check”
on page 2-27 .
Power
Ready
Tractor 2
Paper Out
Font Lock ON
Blinking
Blinking
Blinking
Blinking None Timer Error
Turn the printer off and then back
on. If you get the same error
during power-up, replace the logic
board and readjust the
bidirectional print adjustment.
Go to “Bidirectional Print
Adjustment” on page 4-4 .
Power
Ready
Tractor 2
Paper Out
Font Lock ON
Blinking
Blinking
Blinking
Blinking None Hardware Drive Error
The printhead or the printhead
cable(s) can cause this error. Go
to
“Printhead Service Check”
on page 2-29 .
Turn the printer off and then back
on. If you get the same error,
replace the logic board and
readjust the
“Bidirectional Print
Adjustment” on page 4-4 .
If the printer completes POST
successfully and eventually gets
the same error, go to
“Intermittent Problem Service
Check” on page 2-18
.
LED Status Alarm Action