Onkyo TX SR805 - Manual (Page 103)

103
Zone 2 and Zone 3 —Continued
If you’ve connected your Zone 2 speakers to the AV
receiver, as explained in “Connecting Your Zone 2
Speakers Directly to the AV receiver” on page 101, you
must set the Powered Zone 2 setting to Act (Activated).
Notes:
• When Act is selected and Zone 2 turned on, the Zone 2
speakers connected to the ZONE 2 L/R speaker termi-
nals output sound, but the surround back speakers con-
nected to the SURR BACK L/R speaker terminals do
not. When Act is selected and Zone 2 turned off, the
surround back speakers output sound as normal.
• On the TX-SR875, Powered Zone 2 cannot be used if
the Speaker Type is set to Bi-Amp or BTL (page 45).
• This procedure can also be performed on the AV
receiver by using its [SETUP], [ENTER], and arrow
buttons.
Powered Zone 2 Setting
1 Press the [RECEIVER] REMOTE
MODE button, followed by the
[SETUP] button.
The main menu appears onscreen.
2 Use the Up and Down [ ]/[ ]
buttons to select “7. Hardware
Setup,” and then press [ENTER].
The Hardware Setup menu appears.
INPUT SELECTOR
ON STANDBY
DISPLAY MUTING
GU IDE EXI T
PREV
CH
DIMMER
CDR/MD
SAT TAPE/AMP
SLEEP
MACRO
REMOTE MODE
--/--- 10 11 12
TV
TV CH
TV VOL
PLAYLIST RANDOM
DVD
AUX 1 AUX 2 GAME/TV
CBL/SAT VCR/DVR
D. TUN
CD TUNER TAPE
PHONO
REC
ENTER
TO P M ENU MEN
U
VOL
CH
DISC
ALBUM
TV
VCR
CABLE DOCK
DVD
RECEIVER
CD
+
-
1 2 3 ZONE 3
ZONE 2
INPUT
+
-
+10 0 CLEAR
1 2 3
4 5 6
7 8 9
SE
TUP RET UR N SETUP
RECEIVER
ENTER
RECEIVER
SE
TUP
ENTER
ENTER
3 Use the Up and Down [ ]/[ ]
buttons to select “2. Zone 2/
Zone 3,” and then press [ENTER].
The Zone 2/Zone 3 screen appears.
4 Use the Up and Down [ ]/[ ]
buttons to select “Powered
Zone 2,” and use the Left and
Right [
]/[ ] buttons to select:
Not Act: ZONE 2 L/R speaker termi-
nals not activated (Powered
Zone 2 disabled).
Act: ZONE 2 L/R speaker termi-
nals activated (Powered Zone
2 enabled).
5 Press the [SETUP] button.
Setup closes.
ENTER
ENTER
7-2.Zone2/Zone3
Powered Zone2 Not Act
Zone2 Out Fixed
Zone3 Out Fixed
ENTER
ENTER
SE
TUP