Onkyo TX SR805 - Manual (Page 89)

89
Advanced Setup —Continued
Speaker Distance
With the Speaker Distance settings, you can specify the
distance from each speaker to the listening position.
Note:
• This procedure can also be performed on the AV
receiver by using its [SETUP], [ENTER], and arrow
buttons.
1 Press the [RECEIVER] REMOTE
MODE button, followed by the
[SETUP] button.
The main menu appears onscreen.
2 Use the Up and Down [ ]/[ ]
buttons to select “2. Speaker
Setup,” and then press [ENTER].
The Speaker Setup menu appears.
3 Use the Up and Down [ ]/[ ]
buttons to select “3. Speaker Dis-
tance,” and then press [ENTER].
The Speaker Distance screen appears.
Note:
• Speakers that you set to No or None
in the Speaker Configuration
(page 86) cannot be selected.
These settings are set automatically by the Automatic
Speaker Setup function (see page 55).
RECEIVER
SE
TUP
ENTER
ENTER
2.Speaker Setup
1.Speaker Settings
2.Speaker Config
3.Speaker Distance
4.Level Calibration
5.Equalizer Settings
6.THX Audio Setup
ENTER
ENTER
2-3.Speaker Distance
Unit feet
Left 12.0ft
Center 12.0ft
Right 12.0ft
Surr Right 12.0ft
Surr Back R 12.0ft
Surr Back L 12.0ft
Surr Left 12.0ft
Subwoofer 12.0ft
4 Use the Up and Down [ ]/[ ]
buttons to select “Unit,” and then
use the Left and Right [
]/[ ]
buttons to select:
feet: Select if you want to enter
distances in feet. Can be set
from 0.5 to 30 feet in 0.5-foot
steps.
meters: Select if you want to enter
distances in meters. Can be
set from 0.15 to 9 meters in
0.15-meter steps.
5 Use the Up and Down [ ]/[ ]
buttons to select a speaker, and
use the Left and Right [
]/[ ]
buttons to specify the distance.
Specify the distance from the speaker
to your listening position.
Notes:
• The Center distance cannot be set if
Speaker Type is set to BTL
(page 45), or Center is set to None in
the Speaker Configuration (page 86).
• The Surr Right and Surr Left dis-
tances cannot be set if Speaker Type
is set to BTL (page 45), or Surround
is set to None in the Speaker Config-
uration (page 86).
• The Surr Back R and Surr Back L
distances cannot be set if Speaker
Type is set to Bi-Amp or BTL
(page 45), Surr Back is set to None in
the Speaker Configuration (page 86),
or Powered Zone 2 is being used
(page 103).
• The Subwoofer distance cannot be
set if Subwoofer is set to No (step 4).
6 Repeat step 5 for each speaker.
7 Press the [SETUP] button.
Setup closes.
ENTER
ENTER
ENTER
ENTER
SE
TUP