Oce North America LIGHTJET 430 - Manual (Page 11)

Ø
Routine Maintenance Procedures
45574-F see copyright, disclosure, use and duplication information on pg ii 2-1
2
Routine Maintenance Procedures
NOTE
The LightJet
®
430 is a digital photo printer intended for operation under conditions
of a controlled environment. Photo printers are classified as information technology
equipment (ITE), and are subject to applicable ITE test and working environment
standards. Deployment of this equipment in an environment or under conditions
other than specified and/or recommended may result in degradation of machine
performance.
Preventative Maintenance Service Visits
Customers who hold a service contract for their LightJet
®
430 receive regular Preventative
Maintenance (PM) service visits. During a PM visit, our service engineer will:
1
§ Review customer log and address potential problems
§ Verify acceptable level of image quality
§ Verify media transport operation
§ Verify electrical and optical systems using LJ Explorer
§ Verify that a hard copy of the EEPROM data is on file at the customer site
§ Record software and firmware versions
§ Record ND Light Levels from LJ Explorer / Optical Motors
§ Inspect all optics, clean and adjust if necessary
§ Clean media load and unload area
§ Clean rubber rollers and drum
§ Clean all air filters
Customers who do not have a service contract can request a PM (and provide a purchase order
number) in order to receive this service. To ensure consistent and reliable operation of your
LightJet
®
430, we recommend that a PM service visit be performed every 6 months.
Cleaning Your LightJet
®
430
Cleaning the LightJet
®
430 on a regular basis will prevent build up of particles in the drum and
media transport system that can cause imaging artifact problems. The following schedule is a
guideline only; machines that experience heavy use should be cleaned more often.
Notes:
1
PM activities may change without notice.