One for All URC-3720 - Manual (Page 13)

WWW.ONEFORALL.COM
13
Macros
(Sequence of commands)
Extra Features
Macros (Direct)
You can program your ONE FOR ALL 2 to issue a sequence of commands at
the press of one button. Any sequence of commands you regularly use can
be reduced to one key stroke for your convenience.
Example: To switch off your Television and Satellite Receiver with
one keypress (e.g. red key):
1 Press and hold down the MAGIC key until the red LED
underneath the last selected device key will blink twice. The
red LED will blink once, then twice.
2 Press 9 9 5.
3 Then press the Red key to which the Macro will be assigned.
4 Next press TV, OFF, SAT, OFF.
5 To store the Macro, press and hold down the MAGIC key until the
red LED underneath the last selected device key will blink twice.
The red LED will blink once, then twice.
6 Whenever you press the ”Red” key, the ONE FOR ALL 2 will switch
off your Television and Satellite Receiver.
- Make sure that you program a Macro on a spare key that you don’t use in
any mode.
- Once you program a Macro on a specific key, the sequence will work
regardless of the mode (TV and SAT) you are using.
- Each MACRO can consist of a maximum of 35 key strokes.
- If you had to hold down a key for a few seconds on the
original remote control to get a function, this function may not work in a
macro on your ONE FOR ALL remote.
- To avoid accidental recordings with the ONE FOR ALL 2, you must press
the Record key twice to begin recording. Because of this, we recommend
you not to assign a Macro or Shifted Macro to the Record key.
- If you program a Macro on a key, the original function will become
shifted (excluding REW, PLAY, PAUZE, FF, SKIP Forward, SKIP Back, STOP,
REC, Red, Green, Yellow and Blue). Press the MAGIC then the key to
access it.
SAT/CBL SAT/CBL
DVD DVD
AMP/TUNER AMP/TUNER