One for All URC-3720 - Manual (Page 9)

WWW.ONEFORALL.COM
9
--> If your device does not respond to the ONE FOR ALL 2 after you
have tried all the codes listed for your brand.
--> The Search Method may also work if your brand is not listed at
all.
The Search Method allows you to find the code for your device by scanning
through all the codes contained in the memory of the ONE FOR ALL 2.
Example: To search for your TV code:
1 Switch on your television (not on standby) and aim your ONE FOR ALL
at your TV.
2 Press the TV key on your ONE FOR ALL 2.
3 Press and hold down the MAGIC key
(for appraximately 3 seconds) until the
red LED (underneath the TV key
in this example) blinks twice.
The red LED will blink once, then twice.
4 Press 9 9 1. The red LED will blink twice.
5 Next, press OFF.
- If you wish you may also search for your code using
another function than “OFF”. Simply choose between 0,
1, 2, 3, VOL+, PLAY, STOP or MUTE instead.
6 Aim the ONE FOR ALL 2 at your Device. Now press CH+
over and over, until your e.g. Television switches off.
- Everytime you press the CH+ key the ONE FOR ALL 2 will
send out a POWER signal (the function you chose at step
5) from the next code contained in the memory.
- You may have to press this key many times (up to 150
times) so please be patient.
- If you skip past a code, you can go to the previous
code(s) by pressing the CH- key.
- Remember to keep pointing the ONE FOR ALL 2 at your
Device while pressing this key.
7 As soon as your Device switches off, press the MAGIC
key to store the code.
- If your Device does not switch on pressing the ON key,
simply press the OFF key, a number key or CH+ to switch your e.g.
Television back on.
Search Method
x2