Omron Programmable Terminals NT31 NT31C - Manual (Page 183)

6-9 Section System Settings
173
• PC-PR201H:
Printers that can emulate the PC-PR201H, made by NEC Corp.
• PCL 5:
Printers that conform to the PCL 5 printer control specifications.
Note that the NT31 can only be used with the monochrome Tone setting and
does not support color printing.
For the NT31, the Print Method is fixed as Tone.
The default (factory) setting is ESC/P.
Reference:
S In addition to this setting, NT31C has the Print Method setting (page 174).
S For details on the print function, refer to 2-15-7 Print Function in the Reference
Manual.
Set the printer controller setting by following the menu operation from the Sys-
tem Menu shown below.
Select Maintenance Mode.
Select Memory Switch.
Press Printer Controller to display the re-
quired printer type.
The setting option changes each time the
touch switch is pressed.
Ver 3.10
To set other memory switches, select the relevant screen using the [ ] (next
screen) or [ ] (previous screen) touch switch, then make the setting.
• To confirm the settings and quit the memory switch setting screen, press the
Quit touch switch. The settings made last will be set and the NT31/NT31C will
return to the MAINTENANCE MODE MENU screen.
• To quit the memory switch setting screen without confirming the settings, press
the Abort touch switch. The NT31/NT31C will return to the MAINTENANCE
MODE MENU screen with the previous settings still in effect.