Onkyo TX-NR3008 - Manual (Page 68)

68
En
Screen Centered Dialog
“Screen Ctr Dialog” is a function for moving the Center
image of dialog etc. upwards through use of the front high
speaker to fix the image to the display height.
■ Screen Ctr Dialog
As the value increases, the Center image moves upwards.
` 0:
Screen Centered Dialog off.
`
1 to 5:
Screen Centered Dialog on.
Note
• The “Screen Ctr Dialog” can be used when supported listening
mode is selected and “Center” and “Front High” are set to
effective in “Speaker Configuration” (
➔ 51).
• This setting cannot be used while a pair of headphones is con-
nected.
Re-EQ
With the Re-EQ function, you can compensate a
soundtrack whose high-frequency content is too harsh,
making it more suitable for home theater viewing.
■ Re-EQ
` Off :
Re-EQ Function off.
` On:
Re-EQ Function on.
This function can be used with the following listening
modes: Dolby Digital, Dolby Digital Plus,
Dolby TrueHD, Multichannel, DTS, DTS-HD High Reso-
lution Audio, DTS-HD Master Audio, DTS Express,
DSD, Dolby EX, Dolby Pro Logic IIz Height, Dolby
PLIIx Movie, Neo:6 Cinema and 5.1-channel source +
Neo:6, and Neural Surround.
■ Re-EQ(THX)
` Off:
Re-EQ (THX) Function off.
` On :
Re-EQ (THX) Function on.
This function can be used with the following listening
modes: THX Cinema, THX Surround EX, and
THX Ultra2 Cinema.
Note
• Settings for the Re-EQ function are kept in each listening mode.
However, in THX listening mode, when the AV receiver is
turned off, it will return to “On”.
• This setting cannot be used while a pair of headphones is con-
nected.
Audio Selector
You can set priorities of audio output when there are both
digital and analog inputs.
■ Audio Selector
` ARC:
The audio signal from your TV tuner can be sent to
the HDMI OUT MAIN of the AV receiver.
*1
With this selection the TV’s audio can be automati-
cally selected as a priority among other assignments.
` HDMI:
This can be selected when HDMI IN has been
assigned as an input source. If both HDMI (HDMI
IN) and digital audio inputs (COAXIAL IN or OPTI-
CAL IN) have been assigned, HDMI input is auto-
matically selected as a priority.
` COAX:
This can be selected when COAXIAL IN has been
assigned as an input source. If both coaxial and
HDMI inputs have been assigned, coaxial input is
automatically selected as a priority.
` OPT:
This can be selected when OPTICAL IN has been
assigned as an input source. If both optical and
HDMI inputs have been assigned, optical input is
automatically selected as a priority.
` Multich:
The AV receiver always outputs analog signals from
multichannel analog input.
` Analog:
The AV receiver always outputs analog signals.
Note
• The setting is stored individually for each input selector.
• This setting can be made only for the input source that is
assigned as HDMI IN, COAXIAL IN, or OPTICAL IN.
• To select the digital audio input, see “Digital Audio Input” for
more detail (
➔ 50).
• To select “Multich”, you must assign the multichannel
input(
➔ 50).
*1 You can select “ARC” if you select the TV/CD input selector.
But you cannot select it if you’ve selected “Off” in the “Audio
Return Channel” setting (
➔ 65).