Oregon Scientific SE122 - Manual (Page 7)

EN
6
OPERATING MODES
TIME
CHRONO (Stopwatch) ALARM
Press MODE to switch between:
• Time mode
• Alarm mode
• Chrono (Stopwatch) mode
HR / KCAL MODE
HEART RATE MEASUREMENT
Press / KCAL to enter HR Measurement mode. Press
MODE to return to previous mode.
NOTE When no signals are received or the measurement
is out of range for five minutes, the receiver will automatically
return to the previous operating mode.
HEART RATE LIMITS
The heart rate limits help you determine if you are exercising
within your training zone.
• If you go above your limits will flash
• If you go below your limits will flash
To set the heart rate limits:
1. Press / KCAL to navigate to HR Measurement
mode.
2. Press and hold MODE until appears.
3. Press SET to choose the lower limit, then press MODE
to confirm.
4. Press SET to choose the upper limit , then press
MODE to confirm.
NOTE The upper limit must exceed the lower limit. The
transmitter will adjust the ranges automatically according to
the data entered. You can also activate the heart rate limit
alert function, so the transmitter will emit a beeping sound
when the limits are exceeded.