Oreck WS-7013U - Manual (Page 11)

before permanently mounting.
A. REMOTE TEMPERATURE SENSOR
1. Remove the mounting bracket from the
remote temperature sensor.
2. Mount using either screws or adhesive tape.
3. Reattach the remote temperature sensor to
the mounting bracket.
B. THE TEMPERATURE STATION
1. The indoor temperature station comes with
the table stand already mounted. If you
wish to use the table-stand, all that is
required is to place the indoor temperature
station in an appropriate location.
2. To wall mount, remove the table stand. To
do this, pull down on the stand from the
rear and rotate forward.
a) Fix a screw (not included) into the
desired wall, and place the indoor
temperature station onto the screw using
the hanging hole on the backside.
Gently pull the indoor temperature
station down to lock the screw into place.
TROUBLESHOOTING
NOTE: For problems not solved, please
contact Oreck Customer Service at
1-800-989-3535.
10